螺栓連接的無約束機械聯軸器檢測

螺栓連接的無約束機械聯軸器檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

BS EN 14525-2004不同材料管道用球墨鑄鐵大公差聯接器和法蘭接頭:球墨鑄鐵、灰鑄鐵、鋼、PVC-U、PE和纖維水泥

This document specifies the requirements and associated test methods applicable to wide tolerance ductile iron couplings and wide tolerance flange adaptors intended for use with pipe components made from a number of pipe materials (ductile iron, grey iron, PE, PVC-U, steel, fibre-cement), for providing a leak tight seal over a wide range of pipe external diameters :\n— to convey water (e.g. potable water);\n— with or without pressure ;\n— to be installed below or above ground, inside or outside buildings.\nThis document is not intended to cover sewerage or gas applications, where other requirements may be necessary.\nThis document specifies requirements for materials, dimensions and tolerances, mechanical properties and standard coatings of ductile iron products.\nThis standard covers ductile iron products cast by any type of foundry process or manufactured by fabrication of cast components, as well as corresponding joints, in a size range extending from DN 40 to DN 600, for an allowable operating pressure (PFA) up to 16 bar, for fluid temperatures between 0 ℃ and 25 ℃ excluding frost. For higher temperatures, up to 50 ℃, additional type testing should be carried out.\nIt also gives performance requirements and associated test methods for restrained and non-restrained flexible joints. Joint design and gasket shapes are outside the scope of this standard.\nNOTE 1 PFA may be limited depending on pipe materials effectively connected.\nNOTE 2 In this document, all pressures are relative gauge pressures, expressed in bars (100 kPa = 1 bar).\nNOTE 3 EN 545 gives the specifications for the ductile iron fittings to be used with ductile iron pipes.\nNOTE 4 EN 12842 gives the specifications for the ductile iron fittings to be used with PVC-U and PE pipes.