嬰兒學步車檢測

嬰兒學步車檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB 14749-2006嬰兒學步車安全要求

本標準適用于從能夠獨立坐到能夠自己行走的嬰兒使用的嬰兒學步車（以下簡稱學步車）的安全要求和測試方法。 本標準不適用于醫療用學步車以及氣墊支撐嬰兒的學步車。 嬰兒學步車如附有供兒童玩耍的玩具，應符合相關標準要求。

GB/T 22753-2008玩具表面涂層技術條件

本標準規定了玩具表面涂層的技術要求和試驗方法。本標準適用于各種具有裝飾和防護等功能的玩具表面涂層。本標準不適用于兒童自行車、兒童三輪車、兒童推車、嬰兒學步車的表面涂層。

GB 22793.1-2008家具.兒童高椅.第1部分:安全要求

GB 22793的本部分規定了有關家用兒童高椅的安全要求，目的是大限度地減少兒童高椅和用作兒童高椅的多用途高椅在正常使用或合理性可預見誤用時導致的事故。本部分不適用于可變換成矮椅，矮椅和矮桌以及具有嬰兒學步車、推椅、搖椅、汽車椅和可躺的低椅等高椅的附加功能。本部分不適用于由兒童相互之間在高椅內玩耍可能引起的事故或傷害，或者由3歲以上的兒童濫用或誤用時造成的事故。

GB/T 24329-2009出口兒童高椅安全要求及測試方法

本標準規定了出口兒童高椅的安全要求、測試方法及標志、使用說明。本標準適用于供6個月到36個月之間的兒童使用的出口兒童高椅。本標準不適用于以下兩種情況：多功能兒童高椅調節成嬰兒學步車、推椅、搖椅、汽車座椅及斜躺矮椅等附加功能時；大齡兒童與椅中兒童進行互動或者3歲以上使用者的濫用或不正確使用高椅時。

GB/T 36601-2018電子商務交易產品信息描述 玩具

本標準規定了電子商務交易中玩具類產品信息的描述屬性、描述方法、信息模型、通用信息摘要描述、專用信息摘要描述以及信息擴展方法。本標準適用于電子商務中玩具類產品信息的發布、交換、存儲和管理等。

CNCA 13C-068-2006玩具類產品強制性認證實施規則.童車類產品

本規則適用于設計或預定供兒童乘騎玩耍的童車類產品，包括：兒童自行車(大鞍座高度在435mm～635mm范圍內)兒童三輪車兒童推車嬰兒學步車玩具自行車(大鞍座高度小于435mm)電動童車其它玩具車輛

QB/T 2121-2014童車涂層通用技術條件

本標準規定了童車產品(包括兒童自行車、兒童三輪車、兒童推車、嬰兒學步車)表面涂層的術語和定義、要求、試驗方法。本標準適用于各種具有裝飾和防護等功能的童車表面涂層。

SN/T 0729-2014進出口童車檢驗規程

本標準規定了進出口童車的抽樣、檢驗和檢驗結果的判定的規則。本標準適用于兒童自行車、兒童三輪車、兒童推車、嬰兒學步車的檢驗。兒童乘騎的童車獨輪車、鞍座高度高于435 mm的滑行車、滑板車等的檢驗可參照本標準執行。本標準不適用于電動童車和其他類童車的檢驗。

ASTM F977-2000嬰兒學步車的用戶安全使用標準規范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the baby walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk.1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2003嬰兒學步車的用戶安全使用標準規范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1).1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers.1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk.1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2009嬰兒學步車安規

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2011a嬰兒學步車的標準消費者安全規范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2011b嬰兒學步車消費者安全標準規范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2012嬰兒學步車的標準消費者安全規范

1.1 This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2 This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3 No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4 This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6 The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F977-2018嬰兒學步車用戶安全使用標準規范

1.1x00a0;This consumer safety specification covers performance requirements, test methods, and marking requirements to promote safe use of the infant walker (see 3.1). 1.2x00a0;This consumer safety specification is intended to minimize accidents to children resulting from normal use and reasonably foreseeable misuse or abuse of walkers. 1.3x00a0;No walker produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.4x00a0;This consumer safety specification is not intended to address accidents and injuries resulting from the interaction of other persons with the child in the walker or the accidents resulting from abuse and misuse by children able to walk. 1.5x00a0;The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. 1.6x00a0;The following precautionary caveat pertains only to the test method portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

EN 1273-2005兒童使用和保育用品.嬰兒學步車的安全性要求和試驗方法

This European Standard specifies safety requirements and test methods for baby walking frames into which a child is placed, and intended to be used from when the child is able to sit up by itself until the child is able to walk by itself.This European Standard does not apply to baby walking frames for therapeutic and curative purposes and to those baby walking frames relying on inflatable parts to support the child. NOTE Baby walking frames relying solely on inflatable parts to support the child are excluded from the scope of this standard because of the problem of retaining rigidity of the structure.This European Standard meets the general safety requirement of Directive 2001/95/EC for the risks it covers (source: 09/18/EGEntsch 2008-12-22, Official Journal of the European Union No. L, p. 30).

JS 1273-2013兒童使用和護理用品.嬰兒學步車.安全要求和試驗方法

This Jordanian Standard specifies safety requirements and test methods for baby walking frames into which a child is placed, and intended to be used from when the child is able to sit up by itself until the child is able to walk by itself. This Standard does not apply to baby walking frames for therapeutic and curative purposes and to those baby walking frames relying on inflatable .