60°圓錐管螺紋塞規檢測

60°圓錐管螺紋塞規檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

JB/T 6014-2011柴油機.高壓油管組件.技術條件

本標準規定了柴油機高壓油管組件（以下簡稱高壓油管組件）的結構型式、技術要求、試驗方法、檢驗規則和標志、包裝、運輸及貯存。本標準適用于氣缸直徑在200mm 以內，工作壓力不高于100MPa的柴油機高壓油管組件。

TS 6059-2014塞規和球形塞規手柄

This standard; nominal diameter up to 40 mm with taper shank sizes used with the infinitive infinitive grips and handles nominal diameter gauge used to measure larger than 40 mm gauge, which includes the dimensions of the fixing screws and locking pin. Note - hereinafter in this standard text \"straight handle bar pad and gauge\" statement instead of just \"handle\" statement is used.

BS EN 60423-2007電纜管理用導管系統.電氣裝置用導管的外徑和導管及配件的螺紋

This International Standard specifies outside diameters for conduits used in electricalinstallations or in communication systems and the dimensional requirements for threads. It alsospecifies the dimensional requirements for threads used in associated fittings.It is not applicable to extra heavy-duty electrical rigid steel conduits specified in IEC 60981.