纖維光學環行器檢測

纖維光學環行器檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 18478-2001纖維光學環行器

本標準規定了纖維光學環行器的相關定義、產品分類、技術要求、試驗方法、質量評定程序以及標志、包裝、貯存等條件。 本標準適合于應用在光纖通信和其他光纖技術的環行器。

GB 51123-2015光纖器件生產廠工藝設計規范

本規范適用于光纖器件生產廠新建、擴建和改建的工藝設計。

JJF 1690-2018偏振依賴損耗測試儀校準規范

本規范適用于偏振依賴損耗測試儀的校準。

YD/T 1066-2000纖維光學環行器技術條件

本標準規定了纖維光學環行器的產品分類、技術要求、特性試驗、檢驗、包裝、標志、運輸和貯存等。\t本標準適用于光纖通信和其他光纖技術應用的纖維光學環行器。

GSO IEC 61753-091-2-2013纖維光學互連器件和無源元件.性能標準.第091-2部分：C類非連接單模纖維光學尾纖環行器.受控環境

IEC 61753-091-2:2012 contains the minimum test and measurement requirements and severities which a fibre optic circulator as specified by IEC 62077 should satisfy in order to be categorized as meeting the requirements of circulators used in controlled environments as specified in IEC 61753-1. Keywords: fibre optic circulator

GSO IEC 62077-2014纖維光學互連器件和無源元件.纖維光學環行器.總規范

This International Standard applies to circulators used in the field of fibre optics bearing all of the following features: – they are non-reciprocal optical devices, in which each port is either an optical fibre or fibre optic connector; – they are passive devices in accordance with the categorization and definition provided in IEC 62538; – they have three or more ports for directionally transmitting optical power.

DIN EN 61300-3-29-2015纖維光學互連器件和無源元件. 基本試驗和測量程序. 第3-29部分: 檢查和測量. DWDM器件的光譜傳遞特性 (IEC 61300-3-29-2014); 德文版本EN 61300-3-29-2014

This part of IEC 61300 identifies two basic measurement methods for characterizing the spectral transfer functions of DWDM devices.

DS/EN 62077-2010纖維光學互連器件和無源元件.纖維光學環行器.總規范

IEC 62077:2010(E) applies to fibre optic circulators, which are: - non-reciprocal optical devices; - passive components; - have three or more ports for directionally transmitting optical power. This standard establishes circulator requirements and quality assessment procedures. The changes with respect to the previous edition are listed as: - having substantially increased the number of terms; - having added an informative annex for examle of filtering technologies; - having deleted quality assessment procedures.

BS EN 61300-3-32-2006纖維光學互連裝置和無源元件.基本試驗和測量程序.檢查和測量.無源光學元件的偏振模式色散測量

This part of IEC 61300 presents a number of alternative methods for measuring thepolarization mode dispersion (PMD) of a passive fibre optic device under test (DUT). Thesemethods typically measure PMD using either a frequency domain or time domain approach. Inthe frequency domain, the polarization properties of the DUT are analysed. In the time domainapproach, the pulse delay or broadening is observed.This procedure will cover measurements of both broadband, and narrowband densewavelength division multiplexing (DWDM) passive fibre optic devices. Differences betweenmeasurement practices for these varied classes of passive fibre optic devices will be noted inthe text.This procedure can be applied to laboratory, factory and field measurements of PMD inpassive fibre optic devices. Limitation of the application of some methods will be noted in thetext when necessary.This procedure can be applied to a transmissive or reflective DUT. In the latter case, the DUTconnection is via a coupler or circulator, which should have a known very low PMD value.

BS EN 61753-091-3-2004纖維光學互連器件和無源元件性能標準.U類單模纖維光學有抽頭的循環器.非受控環境

This part of IEC 61753 contains the minimum requirements and severities which a fibre optic circulator shall satisfy in order to be categorised as meeting the requirements of circulator devices used in uncontrolled environments. The requirements cover non-connectorised single mode circulators for category U - Uncontrolled environments.

BS EN 61753-092-6-2007纖維光學互連器件和無源元件性能標準.第092-6部分:O類非連接式單模循環器.非受控環境和連續試驗

This part of IEC 61753 contains the minimum test and measurement requirements andseverities which a fibre optic circulator should satisfy in order to be categorized as meeting therequirements of circulator devices used in outside plant environments. The requirements covernon-connectorized single-mode circulators for caterogy O used in an uncontrolled environmentand a sequential test.