衛生設備用花灑檢測

衛生設備用花灑檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 9195-2011建筑衛生陶瓷分類及術語

本標準規定了建筑衛生陶瓷的分類、術語和定義。本標準適用于建筑衛生陶瓷的設計、生產、質量檢驗、貿易、科學研究、教學等領域。

GB/T 16662-2008建筑給水排水設備器材術語

本標準規定了建筑給水排水設備和器材，包括衛生器具，水嘴，加壓、調節和貯存設備，加熱貯熱設備，地漏，檢查井，建筑水處理設備，游泳池、游樂池設備，冷卻設備，水景設備，雨水利用設備，管材，管件，閥門，計量、檢測儀表等方面的專用術語。本標準適用于建筑給水排水設備和器材的專用術語。

GB/T 35577-2017建筑節水產品術語

本標準界定了建筑節水產品的通用術語及中水和雨水利用、建筑室內節水器具、建筑節水灌溉、建筑節水設備儀器儀表等術語。本標準適用于建筑節水相關產品的設計、研究、計量和統計等。

JC/T 2116-2012非陶瓷類衛生潔具

本標準規定了非陶瓷類衛生潔具的術語和定義、分類、技術要求、試驗方法、檢驗規則、標志和標識、包裝、運輸和貯存。本標準適用于建筑物內和公共場所使用的非陶瓷類衛生潔具。

QB/T 2806-2017溫控水嘴

本標準規定了溫控水嘴的術語和定義、分類及標記、使用條件、材料、配套裝置、要求、單柄三控溫控水嘴、檢測與試驗方法、檢驗規則、標記、包裝、運輸和貯存。\r 本標準適用公稱壓力：普通水壓不大于0.5MPa和高水壓不大于2MPa，冷水溫度4℃～29℃，熱水溫度45℃～85℃的條件下，安裝在盥洗室(洗手間、浴室等)、廚房等衛生設施上，出水口溫度自動受預選溫度控制的冷熱水混合水嘴。

QB/T 4050-2010淋浴器

本標準規定了淋浴器（淋浴柱）的產品分類、要求、試驗方法、檢驗規則及標志、包裝、運輸、貯存。 本標準適用于公稱壓力不大于1.0MPa，水介質溫度不大于90℃條件下，安裝在盥洗室(洗手間、浴室)、淋浴房等衛生設施上使用的淋浴器。 本標準不適用于自帶加熱裝置的淋浴器。

JGJ 367-2015住宅室內裝飾裝修設計規范

本規范適用于住宅的室內裝飾裝修設計，不適用屬于歷史文物保護的住宅的室內裝飾裝修設計。

DB11/ 343-2006用水器具節水技術條件

本標準規定了用水器具，包括：水嘴、便器沖洗閥、便器、水箱配件、衛生設備用軟管、內螺紋連\n接閥門、直角閥、淋浴器、淋浴用花灑在應用時應達到的滿足節水要求的技術指標。

DIN EN 249-2010衛生用具.交聯鑄塑丙烯膠片制淋浴盆.試驗方法和要求.德文版本EN 249-2010

This European standard specifies the requirements for shower trays for domestic purposes made from crosslinked cast acrylic sheet conforming with EN 263 with the aim of ensuring that the product, when installed in accordance with the manufacturer′s instructions, will provide satisfactory performance in use. This standard is applicable to all sizes and shapes of shower trays.

DIN EN 15200-2007衛生設備.多功能淋浴間

This standard specifies requirements and test methods for multifunction shower cabinets (subsequently referred to as unit(s)), used for domestic purposes.This standard does not apply to shower cabinets and shower enclosures.NOTE For the purposes of this standard the term \"domestic purposes\" includes use in hotels, accommodation forstudents and similar buildings, except when special provisions e. g. medical, are required.

BS 6100-7-2008建筑和土木工程.詞匯.第7部分:設備

This part of BS 6100 defines terms for the systems, installations andequipment that:a) provide water, electricity, heat, warm air and gases;b) facilitate internal communication and transport, lighting and wasteremoval.This standard does not define terms outside the curtilage of premises,e.g. water supply and public health engineering, which are both coveredin BS 6100-6.

BS EN 1112-2008衛生開關龍頭.1型和2型供水系統用衛生開關龍頭的淋浴出口.通用技術規范

This European Standard specifies:? the dimensional, leaktightness, mechanical, hydraulic and acoustic characteristics with which showeroutlets shall comply;? the procedures for testing these characteristics.This European Standard applies to shower heads and hand showers of any material used for ablutionarypurposes and intended for equipping and supplementing sanitary tapware for baths and showers.This European Standard applies to shower heads and hand showers connected downstream of the obturatorof the tapware.Integral and remote spray attachments incorporated in tapware (e.g. sink and wash basin mixing valves) arenot covered by this standard.Details of pressures and temperatures are given in Table 1.Table 1 — Conditions of use/Classifications

BS EN 14506-2005防飲用水回流污染設備 自動排水道 C型、H系列

This document specifies:a) field of application;b) requirements for automatic diverters;c) dimensional and the physico-chemical properties and the properties of general hydraulic, mechanical andacoustic design of automatic diverters;d) test method and requirements for verifying these properties. For sanitary tapware (see Clause 2) with integrateddevices, the automatic diverter is only considered to be a backflow protection device if it haspassed the requirements of this document and additionally those of the applicable product standard forthe draw off tap or mixing valve;e) marking and presentation;f) acoustics.This document specifies the characteristics of automatic diverters suitable for use in drinking water systems atpressures up to 1 MPa (10 bar) and temperatures up to 65 °C and for 1 h at 90 °C. They are intended only forinstallation with no downstream closing device.This document is applicable to the product type indicated as follows:i) integrated in spout (outlet);ii) integrated in the mixing body;iii) non-integrated (part of a set) above the maximum water level.This document is not applicable to the product type non-integrated below the maximum water level.

BS EN 15200-2007衛生器具.多功能淋浴房

This standard specifies requirements and test methods for multifunction shower cabinets (subsequentlyreferred to as unit(s)), used for domestic purposes.This standard does not apply to shower cabinets and shower enclosures.NOTE For the purposes of this standard the term \"domestic purposes\" includes use in hotels, accommodation forstudents and similar buildings, except when special provisions e. g. medical, are required.