歡迎訪問中科光析科學技術研究所官網!

免費咨詢熱線
400-640-9567|
稀土類示蹤劑檢測項目報價???解決方案???檢測周期???樣品要求? |
點 擊 解 答??![]() |
本標準規(guī)定了大洋多金屬結核調查的基本內容、方法、樣品測試和處理、試驗測試技術和調查成果等技術內容。 本標準適用于大洋多金屬結核勘查和室內的測試,對某些如鐵錳結殼的調查也可參照使用。
ISO 15366-1:2014 describes procedures to chemically separate and purify uranium and plutonium in dissolved solutions of irradiated light water reactor fuels and in samples of high active liquid waste of spent fuel reprocessing plants, prior to their isotopic analysis by e. g. mass spectrometric method or alpha spectrometry. ISO 15366-1:2014 describes a technique for the separation of uranium and plutonium in spent fuel type samples based on chromatographic method. The procedure applies to samples containing 1 μg to 150 μg Pu (IV) and (VI) and 0,1 mg to 2 mg U (IV) and (VI) in up to 2 ml of 3 mol·l-1 nitric acid solution. It is applicable to mixtures of uranium and plutonium in which the U/Pu-ratio can range from 0 up to 200.
ISO 15366-2:2014 describes procedures to chemically separate and purify uranium and plutonium in dissolved solutions of irradiated light water reactor fuels and in samples of high active liquid waste of spent fuel reprocessing plants, prior to their isotopic analysis by e. g. mass spectrometric method or alpha spectrometry. ISO 15366-2:2014 describes a slightly different separation technique from ISO 15366-1, based on the same chemistry, using smaller columns, different support material and special purification steps, applicable to samples containing plutonium and uranium amounts in the nanogram range and below. The detection limits were found to be 500 pg plutonium and 500 pg uranium.
前沿科學
微信公眾號
中析研究所
抖音
中析研究所
微信公眾號
中析研究所
快手
中析研究所
微視頻
中析研究所
小紅書