偏硅酸檢測

偏硅酸檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB 4706.50-2008家用和類似用途電器的安全.商用電動洗碗機的特殊要求

GB 4706.1-2005的該章用下述內容代替:GB 4706的本部分涉及非專供家庭使用的商用電動洗碗機的安全。此類器具用于洗滌碗碟、玻璃陶瓷器皿、刀叉箸匙等餐具和類似物品，可帶有或不帶水加熱或烘干裝置。對于連接一跳相線和中線的單相器具，其額定電壓不超過250V，其他器具不超過480V。在附錄CC中規定了對避免非飲用水通過反虹吸作用進入水源的要求；利用其他能源形式的器具，其電氣部分也在本部分范圍之內。本部分涉及這類器具所引起的常見危險。

GB 8538-2022食品安全標準 飲用天然礦泉水檢驗方法

本標準規定了飲用天然礦泉水中色度、滋味和氣味、狀態、渾濁度、pH、溶解性總固體、總硬度、總堿度、總酸度、多元素測定、鉀和鈉、鈣、鎂、鐵、錳、銅、鋅、總鉻、鉛、鎘、總汞、銀、鍶、鋰、鋇、釩、銻、鈷、鎳、鋁、硒、砷、硼酸鹽、偏硅酸、氟化物、氯化物、碘化物、二氧化碳、硝酸鹽、亞硝酸鹽、碳酸鹽和碳酸氫鹽、硫酸鹽、耗氧量、氰化物、揮發性酚類化合物、陰離子合成洗滌劑、礦物油、溴酸鹽、硫化物、磷酸鹽、總β放射性、氚、<上標226>Ra放射性、大腸菌群、糞鏈球菌、銅綠假單胞菌、產氣莢膜梭菌的測定方法。本標準適用于飲用天然礦泉水指標的測定。

GB/T 9649.20-2009地質礦產術語分類代碼.第20部分:水文地質學

本部分規定了水文地質學基礎內容、各種水文地質調查、水文地質鉆探、野外水文地質試驗、地下水動態與均衡、水文地質化學、地下水動力學、巖溶水文地質、水資源、礦床水溫地質、土壤改良、各項水文調查成果等水文地質學方面的數據分類與代碼。本部分適用于各類地質礦產信息系統建設，確定數據庫標準體系和數據字典，是制定各類地質數據文件格式標準的基礎標準。

GB/T 14603-2009電子工業用氣體.三氟化硼

本標準規定了電子工業用三氟化硼的技術要求、試驗方法、檢驗規則、標志、包裝、運輸、貯存及安全要求。本標準適用于以氟氣和硼單質為原料，采用直接化合的方法制得并經過純化制取的三氟化硼；和以氟硼酸鈉為原料熱分解法制得并經過純化制取的三氟化硼。主要用于半導體器件和集成電路生產的離子注入和摻雜。

GB/T 28459-2012公共用紡織品

本標準規定了公共用紡織品（床單、被套、枕套、毛巾類和服裝）的術語和定義、要求、抽樣、試驗方法、檢驗規則以及標志和包裝。本標準適用于以純棉、棉滌混紡/交織為原料的公共用紡織品（床單、被套、枕套、毛巾類和服裝），其他原料的產品可參照使用。

HG/T 2568-2021工業偏硅酸鈉

本文件規定了工業偏硅酸鈉的分類、要求、試驗方法、檢驗規則、標志、標簽、包裝、運輸、貯存。本文件適用于工業偏硅酸鈉。注：該產品主要用作洗滌劑、陶瓷減水劑和金屬清洗劑、印染的助劑，還用于人造沸石、造紙脫墨、建筑、原油釆掘工程以及防火材料等方面。

HG/T 4545-2013氯氧化鋯生產廢棄物回收方法

本標準規定了堿法生產氯氧化鋯過程中產生的廢堿液和酸性硅渣的回收方法。本標準適用于堿法生產氯氧化鋯過程中產生的廢堿液和酸性硅渣的回收。

CJJ 76-2012城市地下水動態觀測規程

本規程適用于城市的規劃、建設、防災減災、地下水環境評價、地下水資源管理與保護等的地下水動態觀測。

SY/T 0097-2016油田采出水用于注汽鍋爐給水處理設計規范

本規范適用于陸上油田采出水用于注汽鍋爐給水處理的新建、擴建和改建工程設計。

SN/T 2660-2010食品微生物實驗室菌種保藏方法

本標準規定了食品微生物實驗室常用的菌種保藏的定義、技術原則、技術要求和技術方法。本標準適用于食品微生物實驗室菌種的保藏。

DZ/T 0064.62-2021地下水質分析方法 第62部分:硅酸的測定 硅鉬黃分光光度法

本文件規定了硅鉬黃分光光度法測定地下水中可溶性硅酸的方法。本文件適用于地下水資源調查、評價、監測和利用等水樣中較高含量可溶性硅酸的測定。本方法的定量限(以偏硅酸計)為1.3 mg/L，測定范圍為1.3 mg/L~26 mg/L。含量高于此范圍可稀釋后測定。

DZ/T 0064.63-2021地下水質分析方法 第63部分:硅酸的測定 硅鉬藍分光光度法

本文件規定了硅鉬藍分光光度法測定地下水中可溶性硅酸的方法。本文件適用于地下水資源調查、評價、監測和利用等水樣中較低含量可溶性硅酸的測定。本方法的定量限(以偏硅酸計)為0.06 mg/L，測定范圍為0.06 mg/L~2.6 mg/L。

DB50/T 284-2008重慶市溫泉旅游服務質量規范

本規范規定了重慶市溫泉旅游的水資源開發、服務項目、功能區域與設施設備要求、安全要求、衛生要求、服務人員要求、服務質量監測與持續改進。本規范適用于重慶市的溫泉旅游服務業。

ASTM C289-2003集料的堿性硅酸鹽潛在活性的標準試驗方法(化學方法)

When this test method is used to evaluate the potential reactivity of siliceous components in the aggregate with alkalies in hydraulic-cement concrete, it must be used in combination with other methods. Do not use the results of tests by this test method as the sole basis for acceptance or rejection for sources with regard to ASR. Reactions between a sodium hydroxide solution and siliceous components in the aggregate have been shown to correlate with the performance of some aggregates in concrete structures. The results from this test method can be obtained quickly, and, while not completely reliable in all cases, they can provide useful data. This test method can be employed as a quality control tool to periodically check samples from an existing source with an acceptable service history.1.1 This test method covers chemical determination of the potential reactivity of an aggregate with alkalies in portland-cement concrete as indicated by the amount of reaction during 24 h at 80176C between 1 N sodium hydroxide solution and aggregate that has been crushed and sieved to pass a 300-956;m sieve and be retained on a 150-956;m sieve. 1.2 The values stated in SI units are to be regarded as standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement is given in 5.7.1.

DIN EN 16602-70-21-2015航天產品保證.航天材料篩選用易燃性試驗;英文版本 EN 16602-70-21-2014

This Standard defines a multi-test procedure for the determination of the flammability characteristics of non-metallic materials under a set of closely controlled conditions. The test procedure covers both individual materials and materials used in configuration. This Standard describes a series of tests to provide data for aid in the evaluation of the suitability of materials for use in a space vehicle crew compartment. The data obtained are in respect to the ease of ignition and the flame propagation characteristics of materials. All non-metallic materials are inherently flammable, the degree to which this is true is dependant on the chemical nature of the material itself and the environment to which the material is exposed. In the closed environment of a manned spacecraft this can lead to a potentially dangerous situation and close control is therefore required. This standard may be tailored for the specific characteristics and constrains of a space project in conformance with ECSS-S-ST-00.

DIN EN ISO 105-C12-2006紡織品.色牢度試驗.第C12部分:工業洗滌色牢度(ISO 105-C12-2004)

The standard specifies methods for determining the resistance of the colour of textiles of all kinds exposed to all forms of industrial laundering procedures.

DIN EN ISO 16264-2004水質.用流動分析(FIA和CFA)法和光度檢測法測定可溶性硅酸鹽

This International Standard specifies two methods, i.e. flow injection analysis (FIA) and continuous flow analysis (CFA), for the determination of soluble silicate ions in various types of water (such as ground, drinking, surface, leachate and waste water). Both methods are applicable to the determination of a mass concentration of silicate (SiO(Index2)) ranging from 0,2 mg/l to 20 mg/l (with working ranges 0,2 mg/l to 2,0 mg/l and 2 mg/l to 20 mg/l). Other mass concentration ranges are applicable, provided they cover exactly one decade of concentration units (e. g. 0,02 mg/l to 0,2 mg/l in SiO(Index2)). These methods can be made applicable to seawater by changing the sensitivity and by adapting the reagent and calibration solutions to the salinity of the samples.#,,#