室內家具用針織物檢測

室內家具用針織物檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

ASTM D4771-2019室內家具用針織裝飾織物的標準性能規范

5.1x00a0;Fabrics intended for this end-use should meet all of the requirements listed in Table 1. 5.2x00a0;It should be recognized that fabrics can be produced utilizing an almost infinite number of combinations of construction variables (for example, type of fibers, percentage of fibers, yarn twist, yarn number, warp and pick count, chemical and mechanical finishes.) Additionally, fashion or aesthetics dictate that the ultimate consumer may find acceptable articles made from fabrics that do not conform to all of the requirements in Table 1. 5.2.1x00a0;Hence, no single performance specification can possibly apply to all the various fabrics that could be utilized for this end-use. 5.3x00a0;The uses and significance of particular properties and test method are discussed in the appropriate sections of the specified test methods. 1.1x00a0;This performance specification covers the performance requirements for knitted upholstery fabrics as used in the manufacture of new indoor furniture for general domestic use. These requirements apply to both the wale and course directions for those factors where each fabric direction is pertinent. 1.2x00a0;This performance specification is not applicable to fabrics used in contract, porch, deck, or lawn furniture; nor for woven fabrics, bonded or laminated fabrics, or surface-coated fabrics (such as vinyls and urethanes). 1.3x00a0;The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Note 2. See 6.4.1 for a specific warning. 1.5x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.