不含氣液體瓶裝生產線檢測

不含氣液體瓶裝生產線檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 15732-1995漢字鍵盤輸入用通用詞語集

本標準規定了漢字鍵盤輸入用通用詞語。 本標準適用于漢字鍵盤輸入、方案優化和評測。中文信息處理的其他領域也可參照執行。

GB 16912-2008深度冷凍法生產氧氣及相關氣體安全技術規程

本規程規定了工業氧氣及相關氣體的生產（含設計、制造、安裝、改造、維修）、儲存、輸配和使用中應遵守的要求。本規程適用于新建、擴建和改建的采用深度冷凍法生產氧氣及相關氣體的單位。

GB/T 26995-2011塑料瓶沖洗灌裝旋蓋機通用技術條件

本標準規定了塑料瓶沖洗灌裝旋蓋機的術語和定義、型號、型式、基本參數及工作條件、技術要求、試驗方法、檢驗規則、標志、包裝、運輸與貯存。本標準適用于螺紋密封塑料瓶（以下簡稱“瓶體”）的液體低溫灌裝、常溫灌裝、熱灌裝的回轉式灌旋機（以下簡稱“灌旋機”）。本標準主要適用于飲料、調味品等產品的灌裝，不適用于帶顆粒液態物料、高黏度液態物料的灌裝和液態物料的超潔凈灌裝、無菌灌裝。

GB 50016-2014(2018)建筑設計防火規范(2018年版)

本規范適用于下列新建、擴建和改建的建筑：廠房；倉庫；民用建筑；甲、乙、丙類液體儲罐(區)；可燃、助燃氣體儲罐(區)；可燃材料堆場；城市交通隧道。人民防空工程、石油和天然氣工程、石油化工工程和火力發電廠與變電站等的建筑防火設計，當有專門的標準時，宜從其規定。本規范不適用于火藥、炸藥及其制品廠房(倉庫)、花炮廠房(倉庫)的建筑防火設計。

GB 50177-2005(條文說明)氫氣站設計規范(條文說明)

本文件是標準GB 50177—2005《氫氣站設計規范》 條文說明

GB 50410-2014型鋼軋鋼工程設計規范

本規范適用于新建和改建的型鋼軋鋼工程設計。

YB 4359-2013鋼鐵企業通風除塵設計規范

本規范適用于鋼鐵企業新建、擴建和改建工程的通風除塵系統設計。

QB/T 1487-2005不含氣液體玻璃瓶裝生產線

本標準規定了不含氣液體玻璃瓶裝生產線的設備組成、要求、工作條件、試驗和測試方法、檢驗規則和標志、包裝、運輸、貯存。 本標準適用于灌裝各種不含氣的酒類飲料、糖漿飲料、奶類飲料、果汁飲料、食品調料、農藥乳劑等液體的玻璃瓶裝生產線(以下簡稱“生產線”)。

QB/T 4213-2011飲料機械 聚酯(PET)瓶裝飲料無菌冷灌裝生產線

本標準規定了聚酯（PET）瓶裝飲料無菌冷灌裝生產線的定義、組成、工作條件、要求、試驗方法、檢驗規則和標志、包裝、運輸、貯存。本標準適用于聚酯（PET）瓶裝飲料無菌冷灌裝生產線。

DL/T 5706-2014火力發電工程施工組織設計導則

本導則適用于裝機容量為兩臺300MW及以上燃煤電廠的新建工程。

UL 399-2008飲用水冷卻器

1.1 These requirements cover self-contained drinking-water coolers which employ hermetic refrigerantmotor-compressors and which are designed for connection to alternating-current circuits rated not greaterthan 600 volts in accordance with the National Electrical Code, NFPA 70. The requirements also apply towater coolers which supply both hot and cold water.1.2 These requirements do not include additional requirements applicable to equipment designed for usein hazardous locations as defined in the National Electrical Code, NFPA 70.1.3 A product that contains features, characteristics, components, materials, or systems new or differentfrom those covered by the requirements in this standard, and that involves a risk of fire, electric shock, orinjury to persons shall be evaluated using the appropriate additional component and end-productrequirements as determined necessary to maintain the acceptable level of safety as originally anticipatedby the intent of this standard. A product whose features, characteristics, components, materials, orsystems conflict with specific requirements or provisions of this standard cannot be judged to comply withthis standard. Where considered appropriate, revision of requirements shall be proposed and adopted inconformance with the methods employed for development, revision, and implementation of this standard.

UL SUBJECT 2265A-2004原始設備制造商的信息技術設備用使用一次性甲醇的手持式和可手移動式燃料電池電源裝置調查大綱.發布編號:1

This standard is specified OUTLINE OF INVESTIGATION FOR HAND-HELD OR HAND-TRANSPORTABLE FUEL CELL POWER UNITS WITH DISPOSABLE METHANOL FUEL CARTRIDGES FOR USE IN ORIGINAL EQUIPMENT MANUFACTURER S INFORMATION TECHNOLOGY EQUIPMENT Issue Number 1 .

BS 6739-2009過程控制系統儀表的實施規范:安裝設計和實施

This British Standard gives recommendations for, and guidance on,the design for the installation of instrumentation of measurementand control systems in the process industry, and the implementationand commissioning of this installation. It is intended to be used asa manual of good practice on the site and also to assist those whodesign the installation.