飲用水處理元件檢測

飲用水處理元件檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 19249-2017反滲透水處理設備

本標準規定了反滲透水處理設備(以下簡稱設備)的術語和定義、分類與型號、要求、試驗方法、檢驗規則、標志、包裝、運輸與儲存。本標準適用于采用反滲透膜(卷式、碟管式)技術對水進行除鹽、凈化、分離處理的設備。

GB/T 30306-2013家用和類似用途飲用水處理內芯

本標準規定了家用和類似用途飲用水處理內芯的術語和定義、分類與命名、技術要求、試驗方法、檢驗規則及標志、包裝、運輸、貯存。本標準適用于家用和類似用途飲用水處理內芯(以下簡稱“飲用水處理內芯”)。

GB/T 34241-2017卷式聚酰胺復合反滲透膜元件

本標準規定了卷式聚酰胺復合反滲透膜元件(以下簡稱反滲透膜元件)的分類與型號、要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。本標準適用于卷式聚酰胺復合反滲透膜元件的生產、科研、使用和管理等，其他型式的反滲透膜元件可參考執行。

GB/T 50619-2010火力發電廠海水淡化工程設計規范

本規范適用于火力發電廠及核能發電廠的反滲透法和蒸餾法海水淡化系統設計。

GB 50913-2013醫藥工藝用水系統設計規范

本規范適用于新建、改建和擴建的醫藥工藝用水系統的設計。

CECS 357-2013模塊化水處理系統技術規程

本規程適用于新建、改建和擴建的中小型集中式供水以及再生水深度處理等工程中模塊化水處理系統的設計、施工及運行管理。

CJ/T 169-2018微濾水處理設備

本標準規定了微濾水處理設備的術語和定義、分類和型號、要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。本標準適用于水處理中微濾膜過濾設備的生產和檢驗。

CJ/T 170-2018超濾水處理設備

本標準規定了超濾水處理設備(以下簡稱設備)的術語和定義、分類和型號、要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。本標準適用于水處理中超濾膜過濾設備的生產和檢驗。

CJJ/T 110-2017建筑與小區管道直飲水系統技術規程

本規程適用于民用建筑與小區管道直飲水系統設計、施工、驗收、運行維護和管理。

HY/T 107-2017卷式反滲透膜元件測試方法

本標準規定了卷式反滲透膜元件完整性、氣密性和滲透性能的測試方法。本標準氣密性和滲透性能測試適用于所有卷式反滲透膜元件，完整性測試僅適用于長度為1 016 mm的反滲透膜元件。

HY/T 112-2008超濾膜及其組件

本標準規定了超濾膜及其組件的分類與命名、要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。本標準適用于海水、苦咸水預處理、污水處理、工業級生活用水處理中使用的超濾膜和組件的生產、驗收、檢驗。

NF P41-607-2008建筑物內水調節設備.硝酸鹽排除設備.性能、安全和試驗要求

La présente Norme européenne spécifie les exigences relatives à la construction et au mode de fonctionnement des dispositifs de dénitratation automatiques, régénérés par le sel, échangeurs d'anions, utilisés dans les installations d'alimentation en eau potable à l'intérieur des batiments et raccordés en permanence à l'alimentation principale.

DIN 2001-3-2015小型裝置和非固定式設備的飲用水供應. 第3部分: 替代和緊急供水的非固定式裝置. 裝置供水, 規劃, 建設, 運行和維護指南

The document gives basic requirements for planning, construction, operation and maintenance of non-stationary units for substitute and emergency water supply and for the water, supplied by these units.

DIN 19605-2016水處理用固定式水底過濾器.結構和部件

The document defines the different types of filters for water treatment in water works and describes the technical requirements and parameters. Additional advices for operation and control of the filters are given.

DIN EN 12255-14-2004污水處理廠.第14部分:消毒

This European Standard specifies performance requirements for the disinfection of effluents from wastewater treatment plants. The primary application is for wastewater treatment plants designed for the treatment of domestic and municipal wastewater for over 50 PT.

DIN EN 13443-1-2007建筑物內水處理設備.機械過濾器.第1部分:顆粒額定值80?m～150?m.性能、安全和測試要求

Part 1 of this European Standard applies to mechanical filters for drinking water installations inside buildings, ofnominal size from DN 15 to DN 100, minimum nominal pressure PN10, particle rating of 80 IJm to 150 μm, and maximum design temperature of 30 ℃. It specifies requirements relating to the construction and mode ofoperation of filters and describes relevant methods of testing. It only concerns units which are permanentlyconnected to the mains supply at the point of entry into the building.Part 2 of this European Standard EN 13443-2:2005+A1 is a separate document and deals with filters witha particle size limit less than 80 μm.

DIN EN 13443-2-2007建筑物內水調節設備.機械過濾器.第2部分:顆粒額定值1μm到80μm(不含80μm).性能、安全和測試要求

This document specifies requirements relating to the construction, performance and methods of testing formechanical filters for the removal of suspended matter in drinking water installations inside buildings. It applies tofilters with a filtration rating from 1 pm up to less than 80 μm and which are intended for use in systems with aminimum pressure rating of PN 6, connections between DN 15 and DN 100 and service temperature of less than 30 ℃.This document is applicable to back-washable filters, integral filters and those designed for replaceable cartridges.It only concerns units that are permanently connected to the mains supply at point of entry or point of use.Part 1 of this standard (EN 13443-1) is a separate document and deals with filters with a particle rating between80 μm and 150 μm.

DIN EN 14652-2007建筑物內水處理設備.薄膜分離設備.性能、安全和試驗的要求

This European Standard specifies requirements relating to the construction, performance and methods of testing for membrane separation systems with a particle rating below 1μm,manely microfiltration (MF), ultrafiltration (UF), nanofiltration (NF), and reverse osmosis (RO) for drinking water installations inside buildings, intended to remove from the drinking water marginal concentrations of suspended and colloidal solids, microorganisms, organic molecules and/or to reduce the dissolved solids concentration and applies to systems with a minimum pressure of PN 10, connections between DN 15 and DN 100 and a maximum working temperature of at least 30℃.This European Standard applies to membrane separation systems, whose elements may be partly or entirely cleanable or disposable in accordance with the type of system. It only concerns units which are permanently connected to the mains supply at the point-of-use.A membrane separation system may include, together with the separation device pre-and/or post-treatment devices.For the scope of this European Standard:-- separation device shall comply with this European Standard, i.e. without pre-and/or post-treatment devices.-- where pre-and/or post-treatment devices are incorporated in the system, each of them shall conform to the relevant standard. If this is the case, the complete system shall be considered as conforming as a whole.