混凝土制品脫模劑檢測

混凝土制品脫模劑檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 29423-2012用于耐腐蝕水泥制品的堿礦渣粉煤灰混凝土

本標準規定了用于耐腐蝕水泥制品的堿礦渣粉煤灰混凝土(以下簡稱堿礦渣粉煤灰混凝土)的術語和定義、分類、原材料、技術要求、試驗方法、檢驗規則、貯存與輸送等內容。本標準適用于處于酸、堿、鹽環境下耐腐蝕水泥制品使用的堿礦渣粉煤灰混凝土。

GB 50990-2014加氣混凝土工廠設計規范

本規范適用于新建、擴建和改建的蒸壓加氣混凝土工廠項目的設計。

JC/T 949-2021混凝土制品用脫模劑

本文件規定了混凝土制品用脫模劑(以下簡稱脫模劑)的術語和定義、分類和標記、一般要求、技術要求、試驗方法、檢驗規則以及包裝、出廠、運輸和貯存。本文件適用于非純油類物質的混凝土制品用脫模劑。

JC/T 2126.1-2012水泥制品工藝技術規程 第1部分：混凝土與鋼筋混凝土排水管

本部分規定了混凝土和鋼筋混凝土排水管(以下簡稱為排水管)產品制造過程中的原材料、生產工藝、質量控制以及標志、貯存和運輸等。本部分適用于制造符合GB/T 11836及JC/T 640的鋼筋混凝土排水管和頂進施工法用鋼筋混凝土排水管。

JC/T 2126.5-2012水泥制品工藝技術規程 第5部分：環形混凝土電桿

本部分規定了環形混凝土電桿生產用原材料、生產工藝以及運輸和貯存等技術要求。本部分適用于按GB/T4623生產的環形預應力混凝土電桿、環形部分預應力混凝土電桿和環形鋼筋混凝土電桿。

JC/T 2126.6-2012水泥制品工藝技術規程 第6部分：先張法預應力混凝土管樁

本部分規定了先張法預應力混凝土管樁生產用原材料、生產工藝、檢驗、標志、運輸和貯存以及產品合格證等。本部分適用于按GB 13476-2009制造的先張法預應力混凝土管樁(以下簡稱管樁)。其他離心成型的先張法預應力混凝土樁可參照執行。

JC/T 2351-2016預制混凝土襯砌管片安全生產規范

本標準規定了預制混凝土襯砌管片的安全基礎管理、設備及安全設施、工藝安全規定、作業場所與職業健康安全等安全生產要求。本標準適用于預制混凝土襯砌管片的安全生產管理，其他混凝土制品生產可參照執行。

JTS 167-8-2013水運工程先張法預應力高強潘凝土管樁設計與施工規程

本規程適用于水運工程先張法預應力高強混凝土管樁的設計與施工。

SD 149-1985環形預應力混凝土電桿制造工藝規程(離心成型)

本工藝規程是為貫徹GB 4623-1984《環形預應力混凝土電桿》標準及我部架空電力線路的具體要求而制定的(變電架構也可參照執行)。凡本規程中未作規定的部分,應按有關規范或標準執行。凡采用新技術、新工藝、新材料、新設備時,應通過試驗和驗證后方可使用。

JGJ/T 416-2017建筑用真空絕熱板應用技術規程

本規程適用于民用建筑中采用建筑用真空絕熱板的建筑節能工程的設計、施工及驗收。

TB/T 3433-2016高速鐵路預制先張法預應力混凝土簡支梁

本標準規定了新建高速鐵路預制先張法預應力混凝土簡支梁的技術要求、檢驗方法、檢驗規則、標志與制造技術證明書、保管及運輸和架設。本標準適用于新建高速鐵路預制先張法預應力混凝土簡支梁（以下簡稱先張梁）。

EN 12629-3-2002制作混凝土和硅酸鈣結構產品的機械的安全性.第3部分:滑動和轉臺機械

This part of EN 12629, taken together with EN 12629-1:2000+A1:2010, applies to machines for the manufacture of constructional products of calcium-silicate or concrete, where the mould(s) is(are) mounted on a turning or slide table. The motive power for compressing the mixture is effected either mechanically (Annexes A, B), or hydraulically (Annexes C and D). EN 12629-1:2000+A1:2010 specifies general requirements applicable to machines for the manufacture of constructional products from concrete and calcium-silicate.This document specifies the additional requirements to and/or the deviations from EN 12629-1:2000+A1:2010 specific to the machines it covers.This European Standard deals with all significant hazards pertinent to these machines, when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4).This European Standard specifies the appropriate technical measures to eliminate or reduce risks arising from the significant hazards.This European Standard applies to the machines from the point at which the mixture enters the machine (see point 1 of annexes A, B, C, D) and the point where the pallets for concrete products are brought to the assembly (see point 8 at annexes C and D) until the point where the green products are removed from the machine to the curing system (see point 2 of annexes A, B, C, D).This European Standard deals with the hazards listed in Clause 4 which can arise during the operation and maintenance, including the interfaces, of the slide and turntable machines, when carried out in accordance with the specifications given by the manufacturer or his authorised representative.This standard establishes safety requirements and/or methods of protection which apply to these machines.This document is not applicable to side and turntable machines, which are manufactured before the date of publication of this document by CEN.

EN 13670-2009混凝土結構實現［代替:CEN ENV 13670-1］

This European Standard gives common requirements for execution of concrete structures, it applies to both in-situ works and construction using prefabricated concrete elements. (2)This standard expects the execution specification to state all the specific requirements relevant to the particular structure. (3)This standard is applicable to permanent as well as temporary concrete structures. (4) Additional or different requirements should be considered and, if required, given in the execution specification when using: a) lightweight aggregate concrete; b) other materials (e. g. fibres) or constituent materials; c) special technologies/innovative designs. (5)This standard does not apply to concrete members used only as equipment or construction aids for the execution. (6)This standard does not cover the specification, production and conformity of concrete. (7)This standard is not applicable to the production of precast concrete elements made in accordance with product standards. (8)This standard does not cover safety and health aspects of execution, or third party safety requirements. (9)This standard does not cover contractual issues or responsibilities for the identified actions. NOTE It is within the concept of this standard that supplementing requirements can be given for the individual project in the execution specification, on a national level in a national annex, or on a general basis in European standards for special applications e. g. standards for special geotechnical works.

NF P19-220-2008預制混凝土制品.樹脂粘接混凝土.要求和試驗方法

La présente Norme européenne spécifie les prescriptions communes pour le béton de résine utilisé dans la fabrication de produits préfabriqués en béton. Elle est destinée à être utilisée lors de l'élaboration de documents relatifs aux produits en béton de résine.Les normes de produits en béton de résine définiront des prescriptions particulières pouvant être complémentaires à celles données dans le présent document. Les normes de produits prescriront des valeurs limites pour certaines caractéristiques.Ci-après, quelques exemples d'utilisation du béton de résine: mobilier urbain et de jardin, éléments décoratifs, appuis de fenêtre, batis de machines-outils, éléments de cl?tures, mangeoires et caillebotis pour le bétail, etc.La présente norme n'est pas applicable aux bétons et aux mortiers à liant mixte résine/ciment ainsi qu'aux bétons et mortiers imprégnés de polymère à l'état durci (elle s'applique donc uniquement aux PC, et non aux PCC ou SPCC).

DIN EN 12629-3-2011混凝土和硅酸鈣結構產品生產設備.安全性.第3部分:滑式和轉盤機;德文版本EN 12629-3-2002+A1-2010

This part of EN 12629, taken together with EN 12629-1-2000+A1-2010, applies to machines for the manufacture of constructional products of calcium-silicate or concrete, where the mould(s) is (are) mounted on a turning or slide table. The motive power for compressing the mixture is effected either mechanically (Annexes A,B),or hydraulically(Annexes C and D).

DIN-Fachbericht CEN/TR 15177-2006混凝土耐凍裂試驗.內部結構破壞

This document specifies three test methods for the estimation of the freeze-thaw resistance of concrete with regard to internal structural damage. It can be used either to compare new constituents or new concrete compositions against a constituent or a concrete composition that is known to give adequate performance in the local environment or to assess the test results against some absolute numerical values based on local experiences.Extrapolation of test results to assess different concrete i.e. new constituents or new concrete compositions requires an expert evaluation. NOTE Specification based on these test methods should take into account the behaviour of concrete under practical conditions. There is no established correlation between the results obtained by the three test methods. All tests will clearly identify poor and good behaviour, but they differ in their assessment of marginal behaviour.

DIN-Fachbericht CEN/TR 15678-2008混凝土.地下水和地表水進入土壤的受控有害物質的釋放.新的或未認可的混凝土組成成分和生產混凝土用試驗方法

This Technical Report describes test methods, that when completed, will produce eluates for the assessment of inorganic and organic substances potentially released from either the constituents of concretes (tested within hardened reference concretes) or from production concretes (or test pieces representative of production concretes) whether presented in the pre-hardened/precast state, fresh wet state or pre-packaged.

BS EN 12629-3-2002+A1-2010生產混凝土和硅酸鈣結構件的設備.安全性.滑動和絞盤機

1.1 This part of EN 12629, taken together with EN 12629-1:2000+A1:2010, applies to machines for themanufacture of constructional products of calcium-silicate or concrete, where the mould(s) is(are) mounted on aturning or slide table. The motive power for compressing the mixture is effected either mechanically (Annexes A,B), or hydraulically (Annexes C and D).EN 12629-1:2000+A1:2010 specifies general requirements applicable to machines for the manufacture ofconstructional products from concrete and calcium–silicate.This document specifies the additional requirements to and/or the deviations from EN 12629-1:2000+A1:2010specific to the machines it covers.1.2 !This European Standard deals with all significant hazards pertinent to these machines, when they areused as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (seeClause 4). This European Standard specifies the appropriate technical measures to eliminate or reduce risksarising from the significant hazards.1.3 This European Standard applies to the machines from the point at which the mixture enters the machine (seepoint 1 of annexes A, B, C, D) and the point where the pallets for concrete products are brought to the assembly(see point 8 at annexes C and D) until the point where the green products are removed from the machine to thecuring system (see point 2 of annexes A, B, C, D).1.4 This European Standard deals with the hazards listed in Clause 4 which can arise during the operation andmaintenance, including the interfaces, of the slide and turntable machines, when carried out in accordance with the specifications given by the manufacturer or his authorised representative.This standard establishes safety requirements and/or methods of protection which apply to these machines."1.5 This document is not applicable to side and turntable machines, which are manufactured before the date ofpublication of this document by CEN.

BS EN 13670-2009混凝土結構實現

(1) This European Standard gives common requirements for execution of concrete structures, it applies toboth in-situ works and construction using prefabricated concrete elements.(2) This standard expects the execution specification to state all the specific requirements relevant to theparticular structure.(3) This standard is applicable to permanent as well as temporary concrete structures.