廚房水槽檢測

廚房水槽檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 4214.16-2022家用和類似用途電器噪聲測試方法 廢棄食物處理器的特殊要求

增加：本文件適用于獨立使用的家用和類似用途電動廢棄食物處理器。該器具帶有或不帶有自動程序控制，采用冷水供應，永久連接到供水和排污系統，連接到廚房水槽排水管并置于廚房櫥柜內。代替：GB/T 6881.2—2017、GB/T 6881.3—2002和GB/T 3767—2016可用于測試廢棄食物處理器發射的噪聲。代替：GB/T 3767—2016中所列方法適用于任意尺寸的聲源。當使用GB/T 6881.2—2017和GB/T 6881.3—2002時，應注意包含被測廢棄食物處理器櫥柜的大尺寸滿足GB/T 6881.2—2017和GB/T 6881.3—2002中1.3規定的要求。

SN/T 4847-2017衛生潔具耐急冷急熱性試驗方法

本標準規定了洗面器、洗滌槽、淋浴盆、浴缸等衛生潔具的耐急冷急熱性試驗方法。本標準適用于洗面器、洗滌槽、淋浴盆、浴缸等衛生潔具的耐急冷急熱性的試驗。

UL 150-2004天線旋轉器

1.1 These requirements cover antenna rotators intended for household and commercial use on supplycircuits in accordance with the National Electrical Code, NFPA 70.1.2 An antenna rotator generally consists of:a) A mast-mounted (generally outdoors), motorized drive unit that rotates the antenna to thedesired receiving azimuth,b) An indoor-located (usually near television- or radio-receiving equipment) user-operatedcontrol unit that delivers operating power and direction signals to the drive unit, and,c) A length of multiple-conductor Class-2 circuit cable to electrically interconnect the drive unitand the control unit. Some antenna rotating units may control antenna elevation separately or in addition to azimuth. In some cases, the drive unit may be located indoors.1.3 The power used to drive the motor of an antenna rotator is derived from a circuit complying with Class 2 limitations in accordance with Article 725 of the National Electrical Code, ANSI/NFPA 70.1.4 These requirements do not cover systems that use a stationary antenna and change or rotate thereceiving pattern by electronic or switching means. Such systems are covered by the Standard forAudio-Video Products and Accessories, UL 1492.

UL 174-2004家用電蓄水熱水器

The following changes in requirements are being proposed: 1. Revised Label Requirements for Household Storage Tank Water Heater when Connected to a Supplemental Heat Source.

UL 1863-2004通信電路附件

1.1 These requirements cover telecommunications-circuit accessories, such as jack and plug assemblies,quick-connect terminal assemblies, telephone wall plates, telephone extension cords, cross-connectterminal-block assemblies, maintenance terminal modules, terminal enclosures, cable-splice enclosures,network-interface devices, wire-guide assemblies, and connector boxes.1.2 These devices are intended to be used in telecommunications networks that have an operatingroot-mean-square (rms) voltage to ground less than 150 volts and installed or used in accordance withthe National Electrical Code, ANSI/NFPA 70.1.3 These requirements do not cover telephone equipment such as telephone answering devices,residential telephone instruments, telephone dialers, cordless phones, key systems, and private-branchexchange equipment that is covered by the Standard for Information Technology Equipment – Safety –Part I: General Requirements, UL 60950-1. Also, these requirements do not cover:a) Telephone protectors that are covered by the Standard for Protectors for Paired-ConductorCommunications Circuits, UL 497, andb) Secondary protectors that are covered by the Standard for Secondary Protectors forCommunications Circuits, UL 497A.1.3 revised May 14, 20041.4 These requirements do not cover receiver/transmitter-type devices. Equipment of this type is coveredby the Standard for Audio-Video Products and Accessories, UL 1492, or the Standard for Audio/Video andMusical Apparatus for Household, Commercial, and Similar General Use, UL 6500. These requirementsdo not cover cellular telephones or cellular devices. Equipment of this type is covered by UL 1492.1.4 revised May 14, 20041.5 These requirements may be used, directly or by reference, to investigate portions of other equipment,not classified as telecommunications-equipment accessories, that may be connected to atelecommunications network, insofar as they may be applicable to such equipment.1.6 These requirements do not cover wires and cables intended to be permanently installed in a buildingin accordance with Article 800 of the National Electrical Code, ANSI/NFPA 70.

EN 13310-2015廚房水槽.功能要求和測試方法

This European Standard specifies the functional requirements of and test methods for kitchen sinks for domestic purposes, which ensure that the product, when installed in accordance with the manufacturers' instructions, gives satisfactory performance. NOTE 1 For the purposes of this standard, the term "domestic purposes" includes use in hotels, accommodation for students, hospitals and similar buildings. This document does not specify aesthetic requirements and the overall dimensions of kitchen sinks. It does not apply to industrial kitchen sinks. NOTE 2 All drawings are examples only; other forms are permissible.

GSO EN 695-2011廚房水槽.連接尺寸

This European Standard specifies connecting dimensions for kitchen sinks used for domestic purposes, regardless of the material from which they are manufactured. NOTE 1 For the purposes of this standard the term "domestic purposes" includes use in hotels, accommodation for students, hospitals and similar buildings, except when special medical provisions are required. NOTE 2 The figures are given by way of example; other designs are possible. This European Standard does not apply to industrial kitchen sinks.

GSO EN 13310-2011廚房水槽.功能要求和試驗方法

This European Standard specifies the functional requirements of and test methods for kitchen sinks for domestic purposes, which ensure that the product, when installed in accordance with the manufacturers’ instructions, gives satisfactory performance. NOTE 1 For the purposes of this standard the term "domestic purposes" includes use in hotels, accommodation for students, hospitals and similar buildings. This standard does not specify aesthetic requirements and the overall dimensions of kitchen sinks. It does not apply to industrial kitchen sinks. NOTE 2 All drawings are examples only; other forms are permissible.

NF D12-215-2018廚房水槽. 功能要求和試驗方法

!La présente Norme européenne"détermine les !caractéristiques"fonctionnelles et les méthodes d'essai relatives aux éviers de cuisine à usage domestique qui garantissent que le produit, installé selon les instructions du fabricant, donne une performance satisfaisante.Pour les besoins de la présente norme, le terme " usages domestiques " s'applique à l'utilisation dans les h?tels, logements pour étudiants, h?pitaux et batiments similaires.Ce document ne détermine pas de !caractéristiques"en termes d'esthétique et de dimensions hors tout.!Il"ne s'applique pas aux éviers de cuisine à usage industriel.Tous les dessins ne sont donnés qu'à titre d'exemples ; d'autres formes sont admissibles.

NF D14-400-2008衛生設備.高填料含量的甲基丙烯酸分解物

La présente Norme européenne spécifie des méthodes d'essai permettant de mesurer les caractéristiques des dispersions méthacryliques et des appareils sanitaires produits à partir de ces dispersions par polymérisation.

TS EN 695-2007廚房水槽. 連接尺寸

This standard specifies the connecting dimensions for kitchen sinks for domestic purposes, regardless of the material used for their manufacture. This standard is applicable to kitchen sinks for use in residential (domestic) houses, guest houses and similar premises. This standard does not apply to industrial kitchen sinks.