電氣和電子家用和辦公設備檢測

電氣和電子家用和辦公設備檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB 4706.43-2005家用和類似用途電器的安全 投影儀和類似用途器具的特殊要求

GB 4706.1的該章由下述內容代替： 本部分適用于額定電壓不超過250V的家用和類似用途的投影儀的安全。 不是家庭使用，但可能對公眾造成危險的，例如學校，辦公室，商店及類似場所非人員使用的器具也包括在本部分內。 從實際考慮，本部分涉及室內及周圍所有人員遇到的由器具引發的共同危險。本部分通常不予考慮： ——無人監護的兒童或體弱者使用的器具； ——兒童將器具作為玩具。

DIN EN 50643-2018電氣和電子家用和辦公設備. 邊緣設備的聯網待機功耗測量; 德文版本EN 50643:2018

This standard specifies methods of measurement of electrical power comsumption in networked standby and the reporting of the results for edge equiipment.

DS/EN 50564-2011電氣和電子家用和辦公設備 - 低功耗測量

This European Standard specifies methods of measurement of electrical power consumption and the reporting of the results for a range of electrical and electronic household and office equipment, hereafter referred to as products.This standard- addresses issues associated with measuring electrical power, in particular low power (in the order of a few Watts or less), consumed by mains powered products,- describes in detail the requirements for testing single phase products with a rated input voltage in the range of 100 V a.c. to 250 V a.c. but it may, with some adaptations, also be used with three phase products,- may also be of assistance in determining the e

BS EN 50564-2011家用和辦公電氣電子設備.低功耗的測量

This European Standard specifies methods of measurement of electrical power consumptionand the reporting of the results for a range of electrical and electronic household and officeequipment, hereafter referred to as products.This standard? addresses issues associated with measuring electrical power, in particular low power (inthe order of a few Watts or less), consumed by mains powered products,? describes in detail the requirements for testing single phase products with a rated inputvoltage in the range of 100 V a.c. to 250 V a.c. but it may, with some adaptations, also beused with three phase products,? may also be of assistance in determining the energy efficiency of products in conjunctionwith other, more specific, product standards.The value of energy consumed will depend on the operating mode of the product under test,for instance whether the equipment is in an off mode, in a standby mode or in an activemode. This standard does not specify these modes and so it is not possible to use thisstandard on its own. Instead, it provides a method of measurement with a variety of modeswhich are defined elsewhere.This standard does not? specify safety requirements,? specify minimum performance requirements,? set maximum limits on power or energy consumption,? contain limit values or procedures for verifying compliance with regulatory requirements.